PE Poncho with ball is very popular in many countries, there are football, basketball, golf ball, tennies and rugby ball shape for you choice, the diameter of ball is 6cm, standard Poncho size is 50"x80" fits for all, thickness is 0.02mm, the color of ball and poncho, can customized as your own PMS number, also your logo can be printed on the ball and poncho, it's very easy to carry with keychian. it's ideal for sports events. Poncho Ball,Waterproof Poncho Ball,Emergency Poncho Ball,Plastic Poncho Ball Shijiazhuang Tidy Fashion Trading Co.,Ltd , https://www.raincoatchina.com
First, the version of the picture pixel is not enough
Reason: Document processing issue, publication was not found. Processing: Document re-processing, to avoid the recurrence of this situation: At the time of publication, the same single can be issued a copy of the original draft (to be careful to draft), after proofreading, no problem can be published. If you have any questions, you need to report to the supervisor in time and change the documents.
Second, the layout is not clean
Cause: The CTP exposure energy is not enough. The visual effect of the bottom ash on the layout may not be visible if it is not carefully observed (there are no dots with the enlarger). To avoid the recurrence of this situation: use the eraser pen to eliminate it at the edge of the print, there will be a very clear contrast after wiping. Treatment: Increase CTP exposure energy.
Similar problem processing: The layout is not clean, caused by a variety of problems, the following are summarized below:
1, the speed of the plate machine: In the case of CTP energy standards, the version comes out with a blue background. Adjustable wiper speed.
2, the development temperature in the case of CTP energy standards, the version rushed out of the blue bottom. Raise the development temperature if the speed cannot be adjusted (if the temperature is raised, the dots will be flushed and the speed will be increased)
3. This method is rarely used for punch press of punching machine. In the case that the above 1-2 is invalid, the pressure of the wand can be properly adjusted. (Note: Wool bars are detrimental in the case of the brush plate. The loss and shortening of the wool will affect the effect of the plate.)
Third, the machine has a dirty point
Reason: The version is flushed with dirty spots (supplemented fluid cannot be pumped on)
Remedy: Check if the stick is dirty and wipe clean. In the plate processor operation supplementary development, direct pumping some of the development to add or let go of some of the old developer to add some new developer. (If the development is too long, consider replacing the developer, changing the mind, cleaning the machine)
To avoid the recurrence of this situation: Before each publication, you must first use the waste version several times. Check if the rehydration solution is pumped on. Use a damp sponge to wipe the glue stick.
CTP output common faults and solutions
The common troubles and solutions of the current CTP machines are as follows: