[ Chinese wardrobe network ] Many wardrobe users have encountered the problem of wardrobe deformation, and then immediately find a wardrobe manufacturer to discuss. However, in addition to the poor raw materials and processing skills, the deformation of the wardrobe may also be caused by the user's negligence during use. Today, Xiaobian will take everyone to reveal the inside story of the wardrobe deformation and see what they are deformed. 1. Parts are stacked to cause deformation At the time of production in the factory, due to the large number of plates in the processing, some operators are convenient for the drawing, the plates are stacked at random, or the plates of the stacked plates are not flat, and the other is to lean the plates against the wall. Upper, causing the panel to deform due to its own weight before entering the next process. 2, the effect of finishing putty There are some black-hearted merchants on the market. In order to reduce the cost, the putty prepared by pig blood putty or glue is used. Because the two kinds of putty contain a lot of water, the density of fiberboard and particleboard is particularly strong in the substrate commonly used for panel furniture. Therefore, when one side of the door panel member is not put with putty and the other side is coated with such a water-rich putty, the door panel member is hygroscopic and deformed. 3, improper coating treatment caused the deformation of the plate furniture parts The internal stress of the coating, which forms a certain coating after the coating is cured. Even if there is no external force, an internal stress will be generated. If the internal stress is not handled properly, it will become a bending deformation of the door component. One of the main reasons. 4, the impact of the drying process Many manufacturers are in production. When the board is coated with putty or paint, it should be placed on the drying rack for natural drying. If the rod of the drying rack is too sparse or uneven, the door parts will be dried in the paint. Bending deformation was found during the process. 5. The finishing process causes deformation. During the finishing process, due to improper use of the process and raw materials, the plate is deformed and deformed as the internal stress of the coating changes. You can draw on the face and sew according to the drawing lines.You can also send us the picture,and we can sew the face for you. Cloth Doll Girl,Cute Plush Doll For Baby,Drawing Doll For Kids And Adults,Cute Plush Toy For Kids Nantong Einsame Familie Toy Technology Co.,Ltd , https://www.einsamefamilie.com