How should the baler encounter a failure? Under normal circumstances, we will use a baler, but do not know the details of the baler. In many cases, we encountered some thorny problems in the process of using the balers. We did not know where to start and we were in disarray. So what are the common breakdowns of the baler? What are their solutions? Here we Dongtai fully automatic packaging machine carefully analyzed for everyone: QQ: 1786180632

First, the cassette processing, when the tape stuck in the middle of the roller, or foreign matter can not be plugged out, the processing method is as follows:
a. Remove the hex nut washer.
b. Loosen the two M5 countersunk head screws on the center of the connecting shaft. Since the two screws are fixed on the notch portion of the connecting shaft, the screws must be turned on.
c. Take off the connecting shaft, pick up the upper turbine and remove the jam.
d. Assemble the recovery according to the above cba method.
e. Note that the nut and the L-curvature maintain a gap of 0.3-0.5mm

Second, the baling machine does not automatically tape out of the automatic packaging, in this case, first check the "outgoing tape length adjustment" is at "0", and then see if the banding process is correct, if not, send a foreign object near the roller, also This will cause this situation.

Third, after the tie is not cut, there are many situations that will cause this situation:
a. Too tight adjustment
b. Slips or slippery belts are oily, all located near the tightness adjustment and must be removed by rubbing off the oil.
c. The belt is too tight. Lower the belt drive seat downwards or adjust the motor backwards.
d. Use thinner belts or retract rollers with too much clearance.

Understand these, we can better use the baler, so that the baler gives us greater convenience. News source: http://