Tips: Walk-in high and low temperature (wet heat) laboratory should also remember to maintain!

1. The walk-in high and low temperature (wet heat) laboratory temperature and humidity test system must be operated and maintained by a special person. Strictly follow the system operating procedures to prevent others from operating the system.

2, step-in high and low temperature (wet heat) laboratory long-term shutdown does not affect the effective service life of the system, therefore, the system must be turned on at least once every 10 days; do not repeatedly make the system run in a short time, The number of starts per hour should be less than 5 times, and the interval between each opening and stopping should be no less than 3rain; do not open the door of the walk-in temperature and humidity test system at low temperature to prevent damage to the door sealing tape.

3. System use files should be established to facilitate system maintenance and repair. The use file should record the start and end time (date) of each run of the system, the type of test, and the ambient temperature; when the system fails, the fault phenomenon should be described as much as possible; the contents of the system maintenance and repair should also be as Record in detail.

4. Perform a main power switch (leakage short circuiter) operation test once a month to ensure that the switch acts as a leakage protector when it meets the load capacity. The specific steps are: first confirm that the main power switch is turned "ON", that is, the system is powered, then press the test button. This function is normal if the switch lever of the earth leakage breaker falls.

5. The main box of the walk-in temperature and humidity test system should be protected during use, and should not be subjected to strong collision by sharp objects or blunt instruments.

6. To ensure that the cooling water supply is normal and clean, clean the chiller cooling water filter every 30 days or so. If the cooling water tower of the water supply is clean, the local air quality is relatively poor, and the dust content in the air is very high. Generally, it should be cleaned for about 7 days. Cooling tower reservoir.

7. The leakage, overload and short-circuit protection characteristics of the leakage switch are all set by the manufacturer of Guangdong Hongzhan Technology Co., Ltd., and can not be adjusted freely during use, so as not to affect the performance; after the leakage switch is disconnected due to short circuit, the contact should be inspected. Repairs are required when the contacts are severely burnt or have pits.

8. The test product placed in the walk-in temperature and humidity test system should have a certain distance from the suction and exhaust vents of the air conditioning channel to avoid obstructing air circulation.

9, over temperature protector action test. Set the temperature of the over-temperature protector to be lower than the temperature of the cabinet. If an E0.0 alarm and buzzer sounds, it indicates that the function is normal. After the above test is completed, the temperature protection setting value should be re-set properly, otherwise it may cause improper suspension.

10. Once a year, use a vacuum cleaner to remove dust from the power distribution room and water circuit room. Once a month, use a dry cloth to clean up the water in the drain unit of the suction unit.

Konjac Sponge

100% natural original pure konjac sponge, Konjac sponge for body and face,OEM orders are welcome,FREE SAMPLE! Customize Color

About this item

• Konjac sponge made of nature konjac dietary fiber, protect your skin and remove the dirty on skin very well . it has fine natural vegetable texture, with no preservatives and antibacterials.
• Konjac sponge: which is made by konjac flour and would be a good substitution for common cotton sponge.
  
• it goes deep into your skin and makes it clearer and soother, as if it was breathing freely. It's best suitable for baby's cleaning care because of the specially delicate and sensitive skin.
• The closely woven and soft texture will not irritate skin, it has a natural soothing effect on the dirt of pore, and get massaging and cleaning effects by soft contact.
• Konjac Sponge can doing a expulsion of toxin massage by yourself.
• Take off make-up gently,never course harm to eyelash.
• Konjac Sponge Won't block sewer because it can break down within one week.
• Suitable for All Skin Types! Good for Delicate, Acne–prone, Sensitive Skin, Oily or Dry skin.
• Fashionable Gift Idea for Your Loved Ones, Friends and Family – or Just Treat Yourself.

instructions for use

When you feel your skin is no longer delicate and becomes rough, the konjac sponge makes your skin better by massaging. The sponge becomes gentle and full of elasticity after soaking in water.

Konjac sponge will generate richer foam than our daily use bathing healthcare product when used together with facial cleansers

1. Soak the konjac sponge into hot water for 5 minutes, the soft bathing sponge become swelled and touches gentle

2. After the sponge get totally soft, apply some bathing cream, gently rinse it with your hands until generating rich bubbles, then you can clean your overall body

3. After using , please hang the sponge in a cool and well--ventilated area to dry properly

We have a lof of shape for konjac sponges. heart shape,ellipse shape,flat round shape,and look very delicious cheese shape.and have a lot of animal shape for Beetle shape,Bear shape,Butterfly shape. Drop shape,Shell shape.

if you want to know more about Konjac Sponge,Please contact me or follow us.

Konjac Sponge, 100% natural original pure konjac sponge,Konbjac Sponge For Face And Body, Konjac dietary fibre, konjac sponge jak używać

Ningbo Mauri International Trading Co.,Ltd. , https://www.mauriproduct.com